top of page

Weighing in Motion

Weigh Trucks / trains in motion

Now you can get the LCIC-WIM board with embedded software to weigh trucks & trains in motion for slow and high speed WIM.

The on-board powerful DSP running our advanced algorithm makes all necessary filters and calculates on-the-fly: the weight, speed and distance between axles. The calculated results are sent to the PC via the USB / RS485 port and allows our customers to make the interface with the user.

We also provide the basic utility for the PC that allows you to immediately check your WIM scale either for truck or trains.

Specifications Load Cell input

  • 5 Volt excitation for up to 10 load cells in parallel (350 Ohm)

  • Compatible with 1,2,3 mV/V strain gage load cells

  • Low noise wide bandwidth amplifier & 24 bit ADC

  • Standard interfaces

  • USB 2.0 Full Speed compatible

  • Combined RS232/RS485.


  • 4 opto-isolated solid state relays rated at 50V, 300mA Configurable as setpoints, latching alarms or user outputs. Each with status LED.

  • Adjustable Analog output (0 - 2.5V) with 16 bit resolution.


  • 4 opto-isolated inputs with 10-30 VDC range. Each with status LED

  • Input #2 configurable as high speed counter

  • Input #1 configurable as sample trigger (option)

Dimensions (mm)

  • Standard OEM model 160 x 100mm (1/2 Eurocard)

  • ABS cased (option) Standard OEM model 160 x 100mm (1/2 Eurocard)

  • ABS cased (option)

Software included:

  • LCIC-WIM Calibration Wizard software is included with each board

  • Drivers and examples for programmers on how to communicate with the board

  • PC application software for easy start-up for each one of our embedded applications

The main screen of our WIM application for trucks:

ficture - wim application for trucks.jpg

 Results report produced by LCIC-WIM card

Ficture - reported by the LCIC-WIM board

Contact Us...  |  Tel: 972-4-8110877

bottom of page