top of page

Load Cell Tester model LCT-Ultimate

This most advanced Load Cell Tester model LCT-Ultimate is a stand-alone hand-held device that was especially designed for full trouble shooting of strain-gage based load cells. The LCT-Ultimate can check all common types of standard load cells that are available on the market:

4 or 6 wires @ all rated gain outputs.

The LCT-Ultimate provides the user with all essential data needed about the tested load-cell:

  • Bridge resistance and integrity

  • Physical distortion (possibly caused by overload, shock, load or metal fatigue)

  • Checks insulation resistance (can point to moisture or chemical ingress)

 

 

Main Features

  • Fast testing of load cells and scales

  • Can be used to check multi load-cell scale alignment.

  • Continuous signal reading allows for checking linearity and repeatability

  • Very user friendly, full test within 5 seconds

 

Specifications

  • Input and Output resistance: up to 1250 ohm at 0.5 ohm resolution

  • Sense resistance (for 6 wire L/C): up to 500 ohm at 0.1 ohm resolution

  • Insulation resistance: measurement range
    10 MΩ -- 5000 MΩ.

  • Load cell output in percentage of full scale: ± 250% at 0.01% resolution (input load > 50?)

  • Gain adjustment: 0.1 - 5 mv/V steps of 0.01

 

General

  • Power source: 4 AA batteries (not supplied)

  • Connector: 8 pin screw terminal (supplied with the unit).

  • Enclosure material: ABS

  • Display: 16x2 alphanumeric

  • Size: 150mm x 80mm x 28mm

  • Weight: 250gr.

Load Cell Tester   IMS

Hardware and Accuracy

  • Bridge testing: 1.25 Vdc

  • High resistance testing: 10 Vdc

  • A/D resolution: 16bit

  • Resistance accuracy: ± 1 ohm

  • High-resistance accuracy: 10%

  • Load Cell output accuracy: 0.1%

Contact us

 sales1@ims.co.il  |  Tel: 972-48110877

LCT-Ultimate

bottom of page